GCC 12 Instruccion De Instalación

The LocalTalk cable system connects to AppleTalk-compatible networks. This connection
forms a chain; do not connect devices so that it forms a circle.
Important: You need a connector kit for each device on the network. Therefore, you need
two connector kits to connect the printer to one computer, and so forth.

To plug in LocalTalk cables:

1.

Switch off the printer.

2.

Connect one LocalTalk connector box to the

LocalTalk port on the printer.

3.

Connect one LocalTalk connector box to the

printer port (identified by a printer icon) on

the back of the Macintosh. 

4.

Connect the LocalTalk boxes together with

one of the LocalTalk cables. You will only

need one LocalTalk cable (for one Macintosh

and one printer).

5.

You may need to install terminator resistors

that were included in your kit.

6.

Switch on the printer.

7.

Verify the printer’s LocalTalk setting. The 8-pin

serial submenu, accessed from the printer’s

control panel, should be set to LocalTalk.

LocalTalk is the factory default, so you should

not need to change the setting. 

See Elite 12ppm users manual

PhoneNET

Connector box

Resistor

Terminator

Cable