Allworx 9224 Guía Del Usuario
Phone Guide – 9224
3. Press
the
Select button
.
4. Select
the
YES soft key to clear call history OR select NO to cancel.
7.6 Refresh Directory
If new users or extensions have been set up on the Allworx server, the on-phone directory will automatically be
updated after some delay. The directory may be updated immediately using the following procedure:
updated after some delay. The directory may be updated immediately using the following procedure:
1. Select
the
CONFIG soft key.
2. Scroll down and highlight Refresh Directory.
3. Press
the
Select button
.
4. Select
the
EXIT soft key to exit the Refreshing the Directory screen.
7.7 Network Settings
Warning: Do not make any changes to your network settings unless instructed by your System
Administrator.
1. Select
the
CONFIG soft key.
2. Scroll down and highlight Network Settings.
3. Press
the
Select button
.
a. DHCP – Allows the phone to extract its configuration from the server.
i. Enabled
(Default)
ii. Disabled
b. VLAN – Allows the phone to stay on the same network without any hardware reconfiguration.
i. Enabled
ii. Hub Debug Mode
iii. Disabled
(Default)
c. Auto NAT – Setting for a remote phone behind a firewall. See the System Administrator.
i. On
ii. Off
d. Remote Plug ‘n’ Play – Key used to set up a remote phone. See the System Administrator.
e. Edit Boot Server IP – The WAN IP address the server is using for the setup of a remote phone.
f. Edit Time Server IP – Option to change the Time Server the phone is logged into.
g. Edit Contact Serv IP – May be required for remote phones connected via MPLS networks. See
the System Administrator.
h. Edit Phone IP – Option will appear if DHCP is disabled. Allows the manual entry of the phone’s
IP.
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2008 Allworx. All rights reserved
Version 1. Revised: October 31, 2008
Page 22