Billion 5100 Guía Del Usuario

 

84

file via console port. 

3 

The default username is “admin”. The default password is “admin”. The Password and 

Username fields are case-sensitive. Make sure that you enter the correct password and 

username using the proper casing. 

4 

It is highly recommended to change the default username and password. Make sure 

you store the username and password in a save place. 

I cannot access the BIPAC-5100/5100W from the LAN or ping any computer on the LAN. 

1 

Check the Ethernet LEDs on the front panel. A LAN LED should be on if the port is 

connected to a computer or hub. If the 10M/100M LEDs on the front panel are both off, 

refer to Section A.1.2. 

2 

Make sure that the IP address and the subnet mask of the BIPAC-5100/5100W and 

your computer(s) are on the same subnet. 

Initialization of the ADSL connection failed. 

1 

Check the cable connections between the ADSL port and the wall jack. The DSL LED 

on the front panel of the BIPAC-5100/5100W should be on. 

2 

Check that your VPI, VCI, type of encapsulation and type of multiplexing settings are the 

same as what you collected from your telephone company and ISP. 

3 

Restart the BIPAC-5100/5100W. If you still have problems, you may need to verify your 

VPI, VCI, type of encapsulation and type of multiplexing settings with the telephone 

company and ISP. 

I cannot get a WAN IP address from the ISP. 

1 

The ISP provides the WAN IP address after authenticating you. Authentication may be 

through the user name and password, the MAC address or the host name. 

2 

The username and password apply to PPPoE and PPoA encapsulation only. Make sure 

that you have entered the correct Service Type, User Name and Password (be sure to 

use the correct casing).