Billion 5100 Guía Del Usuario

 

82

DSL service. 

3 

Reset your ADSL line to reinitialize your link to the DSLAM. For details, refer to the 

Maintenance chapter (web configurator) or the System Information and Diagnosis 

chapter. 

4 

If these steps fail to correct the problem, contact your local distributor for assistance. 

I cannot access the BIPAC-5100/5100W via the console port. 

1 

Make sure the BIPAC-5100/5100W is connected to your computer's serial port. 

2 

Make sure the communications program is 

configured correctly. The communications 

software should be configured as follows: 

VT100 terminal emulation.

 

9600 bps is the default speed on leaving 

the factory. Try other speeds in case the 

speed has been changed. 

No parity, 8 data bits, 1 stop bit, data flow 

set to none. 

3 

Make sure you entered the correct password. The default password is “admin”.

 

If you have forgot your username or password, refer to Section A.5. 

I cannot telnet into the BIPAC-5100/5100W. 

1 

Check the LAN port and the other Ethernet connections. 

2 

Make sure you are using the correct IP address of the BIPAC-5100/5100W. Check the 

IP address of the BIPAC-5100/5100W. 

3 

Ping the BIPAC-5100/5100W from your computer. 

If you cannot ping the BIPAC-5100/5100W, check the IP addresses of the 

BIPAC-5100/5100W and your computer. Make sure your computer is set to get a 

dynamic IP address; or if you want to use a static IP address on your computer, make 

sure that it is on the same subnet as the BIPAC-5100/5100W. 

4 

Make sure you entered the correct password. The default password is “admin”. 

If you have forgot your username or password, refer to Section A.5. 

5 

If these steps fail to correct the problem, contact the distributor.