3com 812 Manual De Usuario
B
CLI Command Description
CLI Commands
ADD
Use the ADD command to define:
Networks you will connect to
Hosts you need to access
SNMP communities
Users who will dial out, dial in, access the network, or use the CLI
Note that some parameters have default values.
add access
<ip subnet address>
The access list defines which Remote IP Subnets are allowed access to the
Management services of the OCR812. Use this command to add an entry to the
list.
Management services of the OCR812. Use this command to add an entry to the
list.
add auto_filter
eth_blk_dst
Automatically adds and enables a blocking destination subnet address on the
Ethernet interface.
Ethernet interface.
Address - IP address of the subnet to be blocked.
Mask - IP netmask of the subnet to be blocked.
add auto_filter
vc_blk_netbios
Automatically adds and enables an input filter on the specified VC. The filter DP
ports 137 and 138, and TCP ports 139 and 143.
ports 137 and 138, and TCP ports 139 and 143.
VC - Specified VC profile name.
add bridge network
<network_name>
{ enabled [yes] }
Defines a bridge network connection, so your LAN users can bridge to other LANs
across the WAN. bridging is supported over the WAN.
across the WAN. bridging is supported over the WAN.
Note that routing takes precedence over bridging, so that bridging will not occur
unless you disable routing for the protocols you wish to bridge. The protocols to
bridge, and other important parameters, are specified in the user you use to
establish this connection.
unless you disable routing for the protocols you wish to bridge. The protocols to
bridge, and other important parameters, are specified in the user you use to
establish this connection.
Parameter
Description
ip subnet address
IP address in the xx.xx.xx.xx/mask format.