3com 7000 Manual Suplementario
Configuring VP Tunnels
225
Enable Port for VP
Tunneling
Enables a port of the CoreBuilder 7000 family ATM switch for VP
tunneling. A port can be enabled or disabled. VP tunnels can only be
configured if VP tunneling is enabled for the port. Once a port is enabled
for VP tunneling it cannot be used as an ordinary port. For more
information, see “VP Tunneling” on page 5-101.
tunneling. A port can be enabled or disabled. VP tunnels can only be
configured if VP tunneling is enabled for the port. Once a port is enabled
for VP tunneling it cannot be used as an ordinary port. For more
information, see “VP Tunneling” on page 5-101.
Command Actions
Command Result
Example
Enter:
1 1 9 2 2 5.1
The following message is displayed:
Port <5.1> is now tunnel port.
Enter the menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(9) VPT: VP Tunneling Setup
(2) TPS: VP Tunneling Ports Setup
(2) ATP: Add VP Tunneling Port
Enter a parameter at the prompt
Parameter
Format or Range
Port ID
slot.port
Direct access sequence:
1 1 9 2 2
[parameters]
System action taken:
The port is enabled for VP Tunneling. The change takes
place immediately.
place immediately.
System message display:
Port <slot.port> is now tunnel port.