3com 7000 Manual Suplementario
Configuring VP Tunnels
223
Disable VP Tunneling
Mode
Disables the VP tunneling mode of the CoreBuilder 7000 family ATM
switch. The mode can be enabled or disabled. VP tunnels can only be
configured if the VP tunneling mode is enabled. For more information,
see “VP Tunneling” on page 5-101.
switch. The mode can be enabled or disabled. VP tunnels can only be
configured if the VP tunneling mode is enabled. For more information,
see “VP Tunneling” on page 5-101.
The VP tunneling mode will be disabled only after the next reboot.
Command Actions
Command Result
Example
Enter:
1 1 9 1 3
The following message is displayed:
VP TUNNELING mode will be disabled for the next reboot.
Enter the menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(9) VPT: VP Tunneling Setup
(1) MOD: VP Tunneling Mode Setup
(3) DVP: Disable VP Tunneling Mode
Direct access sequence:
1 1 9 1 3
System action taken:
The VP tunneling mode of the CoreBuilder 7000 family
ATM switch is disabled. The change will take place
after the next reboot.
ATM switch is disabled. The change will take place
after the next reboot.
System message display:
VP TUNNELING mode will be disabled for
the next reboot.