3com 7000 Manual Suplementario
226
C
HAPTER
7: C
ONFIGURING
V
IRTUAL
C
HANNELS
Disable Port for VP
Tunneling
Disables a port of the CoreBuilder 7000 family ATM switch for VP
Tunneling. A port can be enabled or disabled. VP tunnels can be
configured only if VP tunneling is enabled for the port. Once a port is
disabled for VP tunneling it can be used as an ordinary port. For more
information, see “VP Tunneling” on page 5-101.
Tunneling. A port can be enabled or disabled. VP tunnels can be
configured only if VP tunneling is enabled for the port. Once a port is
disabled for VP tunneling it can be used as an ordinary port. For more
information, see “VP Tunneling” on page 5-101.
Command Actions
Command Result
Example
Enter:
1 1 9 2 3 4.1
The following message is displayed:
Port <4.1> is no longer tunnel port.
Enter the menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(9) VPT: VP Tunneling Setup
(2) TPS: VP Tunneling Ports Setup
(3) RTP: Remove VP Tunneling Port
Enter a parameter at the prompt
Parameter
Format or Range
Port ID
slot.port
Direct access sequence:
1 1 9 2 3
[parameters]
System action taken:
The port is disabled for VP Tunneling. The change
takes place immediately.
takes place immediately.
System message display:
Port <slot.port> is no longer tunnel
port.