3com S7906E Guía De Referencia
1-3
Table 1-1 display rrpp brief command output description
Field
Description
Flags for Node Mode
RRPP node mode: M represents master node, T represents transit
node, E represents edge node and A represents assistant edge node
node, E represents edge node and A represents assistant edge node
RRPP Protocol Status
RRPP protocol status: Enable (globally enabled)/Disable (globally
disabled)
disabled)
Number of RRPP Domains
Number of RRPP domains configured
Domain ID
RRPP domain ID
Control VLAN
Control VLANs of an RRPP domain: Major and Sub
Protected VLAN
List of VLANs protected by the RRPP domain. MSTIs are displayed
here. To get the VLANs corresponding to these MSTIs, use the
display stp region-configuration command.
here. To get the VLANs corresponding to these MSTIs, use the
display stp region-configuration command.
Hello Timer
Hello Timer value configured in seconds
Fail Timer
Fail Timer value configured in seconds
Ring ID
RRPP ring ID
Ring Level
RRPP ring level, with 0 representing primary ring and 1 representing
subring
subring
Node Mode
Node mode
Primary/Common Port
Primary port when the node mode is master node or transit node;
common port when the node mode is edge node or assistant edge
node; “-“ appears when the port is not configured on the ring or the
board to which the port belongs does not start.
common port when the node mode is edge node or assistant edge
node; “-“ appears when the port is not configured on the ring or the
board to which the port belongs does not start.
Secondary/Edge Port
Secondary port when the node mode is master node or transit node;
edge port when the node mode is edge node or assistant edge node;
“-“ appears when the port is not configured on the ring or the board to
which the port belongs does not start.
edge port when the node mode is edge node or assistant edge node;
“-“ appears when the port is not configured on the ring or the board to
which the port belongs does not start.
Enable Status
RRPP ring status: Yes indicates enabled and No indicates disabled.
display rrpp ring-group
Syntax
display rrpp ring-group [ ring-group-id ]
View
Any view
Default Level
1: Monitor Level
Parameters
ring-group-id: Ring group ID, in the range 1 to 8.