3com 5012 Manual De Usuario
3Com Router 5000/6000 Family
75
Command Reference
ftp timeout
Use the
ftp timeout
command to set the idle-timeout timer.
System view
ftp update
Use the
ftp update
command to set the file update mode that the FTP server uses while receiving data.
System view
fxo-monitoring
Use the fxo-monitoring enable command to enable the on line monitoring function on all FXO interfaces of the device.
Voice view
gateway-list
Use the
gateway-list
command to configure IP addresses of the egress GW routers used by DHCP
clients.
DHCP Address Pool view
get
Use the
get
command to FTP a file from a remote server and save it.
FTP Client view
get
Use the
get
command to download and save a file from a remote server.
SFTP Client view
gk-2nd-id
Use the
gk-2nd-id
command to configure the name and IP address of the backup GK Server corresponding
to the gateway.
Use the
gk-2nd-id
command to configure the IP address, name and port of the backup GK Server.
Voice GK Client view
gk-client
Use the
gk-client
command to enter Voice GK client view, and configure the GK parameters for voice.
Voice view
gk-id
Use the
gk-id
command to configure the GK Server name and IP address corresponding to the gateway.
Use the command
gk-id
to configure such information as the IP address, name, and port of GK Server to
facilitate the research for the right GK Server equipment by the GK Client according to this information, so
as to implement the register task of gateway in the GK Server.
as to implement the register task of gateway in the GK Server.
Voice GK Client view
gk-security call
Use the
gk-security call enable
command to enable security calls on the GK Client (router).
Voice GK Client view
gk-security register-pwd
Use the
gk security register-pwd
command to set the GK register password.
Use the
gk-security register-pwd
command to remove the GK register password.
Voice GK Client view
gratuitous-arp-learning enable
Use the
gratuitous-arp-learning enable
command to enable the address learning function of gratuitous
ARP.
System view
gratuitous-arp-sending enable
Use the
gratuitous-arp-sending enable
command to configure the system to return ARP responses
when receiving gratuitous ARP packets from other network segments. The system, however, does not learn
the received ARP entries.
the received ARP entries.
System view
gre checksum
Use the
gre checksum
command to configure the two ends of a tunnel to perform end-to-end check,
verifying the correctness of packets and discard those that do not pass the verification.
Tunnel Interface view
gre key
Use the
gre key
command to set identification keyword of the tunnel interface, and by this feeble security
mechanism avoid incorrectly identifying or receiving packets from undesired places.
Tunnel Interface view