Gestetner f540 Manual Suplementario

Transmitting IP-Fax

103

❒ If you do not want to specify

other destination, proceed to
step 

.

KKKK

{{{{Start}}}} key.

The IP-Fax transmission begins.

This section describes how to send fax
messages by specifying an alias fax
number of a destination stored in the
gatekeeper.

Preparation
You need to set the gatekeeper ad-
dress as well as alias fax number
beforehand with IP-Fax Parameter
settings. See p.44 “IP-Fax Parame-
ter Settings”.
Also, you need to make settings for
using the gatekeeper for IP-Fax
transmission with user parame-
ters. For information about making
these settings, see p.166 “User Pa-
rameters” (switch 32, bit 0).

❒ Alias fax numbers are fax numbers

stored in the gatekeeper and valid
only within the network.

❒ If you change the settings for using

or not using the gatekeeper, you
need to program the destinations
for the Quick Dial or Speed Dial
again. Normal IP-Fax transmission
is not possible without performing
this procedure.

AAAA

BBBB

{{{{F1}}}}

{{{{F10}}}}) assigned to the Internet

The display for entering an ad-
dress appears.

❒ On Type 2 machines, the Inter-

net FAX function is pre-as-
signed to the 

{{{{F5}}}} key.

❒ Use the following to specify an

alias fax number without press-
ing the user function key:
• Quick Dial, Speed Dial or

Group Dial, assigned to the
destination IP address

• The Redial function

Reference
Chapter 2 "Dialing", Basic Fea-
tures
Chapter 3 "Redial", Advanced
Features

If the Network Transmission Auto 
Check Function Is Turned Off

If the Network Transmission Auto
Check function is set to "Off" with
user parameters, select "IP-Fax Ad-
dress" in the display that appears.
For information about changing
this setting, see p.166 “User Pa-
rameters” (switch 32, bit 1).

ZHMS170E