Preh mc12t3 Guía Del Usuario

14

The infinitely variable adjustment of the swinging strength is carried out with two setting screws in the foot of the
monitor. The pulling strength (1-3 Nm) should be about the same on both screws.

For the adjustment it is best to use a 4 mm Allan key which is fixed to the foot of the
touchscreen/TFT monitor from below (see pict. 3 and pict. 6).

Note: On changing the housing position you should be careful not getting your fingers too
near to the opening on the rear side of the housing as they might get stuck there.

The new calibrating is always necessary if another touchscreen/TFT monitor was
connected to the computer or if the screen resolution was changed. This means that due
to this calibrating the computer is adjusted to the mechanical features of the special
touchscreen/TFT monitor which is at that time connected to the computer.

Integrated in the Preh Touch Commander there is the serial Accu Touch Controller
E271-2210 (Controller model Smart Set 2xx0). It is firmly adjusted to 9600 Bps.
Normally this is clearly recognised by the setup programs. If, however, it is not clearly
recognised, the adjustment can be done by hand or be restarting the corresponding
setup program.

Common informations for the driver installation are in the file:

D:\TOUCH\ELO\README.TXT

You find detailed information in the path, named with your operating system. (The CD-
ROM drive of your Preh-CD is here defined with the letter „D“).

Common informations for the driver installation are in the file:

D:\TOUCH\MICRO\README.TXT

You find detailed information in the path, named with your operating system. (The CD-
ROM drive of your Preh-CD is here defined with the letter „D“).