Netgear WAC730- ProSAFE® Business 3 x 3 Dual Band Wireless-AC Access Point Manual De Usuario

If available, read the release notes before upgrading the software.

Open a web browser from a computer that is connected to the same network as the access 
point or to the access point directly through an Ethernet cable.

In the address bar, enter the IP address of the access point.

A login window opens.

Enter the user name and password.

The user name is admin. The default password is password. The user name and 
password are case-sensitive.

Select Maintenance > Upgrade > Firmware Upgrade.

Click the Choose File button and locate and select the image upgrade file.

The image upgrade file is a .tar file.

Click the Apply button to initiate the upgrade process.

During the upgrade process, the access point automatically restarts. The upgrade 
process typically takes several minutes. When the Test LED turns off, wait a few more 
seconds before doing anything with the access point.

Verify that the new software file was installed by selecting Monitoring > System.

The System page displays. The firmware version is shown in the Access Point 
Information section of the page.

To use this method, you need access to a TFTP server.



Download the new software file from the NETGEAR website and save it to your hard 
disk.

Place the software file in your TFTP server location.

If available, read the release notes before upgrading the software.

Open a web browser from a computer that is connected to the same network as the access 
point or to the access point directly through an Ethernet cable.