Cisco Cisco ONS 15600 Multiservice Switching Platform (MSSP) Guía De Instalación

Read the Release Notes for Cisco ONS 15600 Release 9.2.1.

Using the CTC software, log into the node that you will upgrade. For detailed instructions, refer to the 
Cisco ONS 15600 Procedure Guide. 

Complete the 

.

Disable all other Ethernet devices (such as a dial-up adapter) on the workstation that runs CTC. For 
instructions, contact the Cisco Technical Assistance Center (TAC).

If you have multiple IP addresses on your workstation, you should remove them; you cannot run 
SoftwareR9.2.1.x if multiple IP addresses are configured. 

Verify that TSC cards are installed in Slots 5 and 10, and that the TSC in Slot 10 is active.

If the TSC in Slot 5 is active, select the slot, and right-click to display a menu. Click Soft reset Card. 
The reset takes a few minutes, and resets the TSC card in Slot 10 as the active TSC.

Complete the 

.

Ensure that your workstation is one of the following:

This procedure steps you through the critical information checks and tasks 
you must complete before beginning an upgrade to R9.2.1.x.

PC or UNIX workstation; Cisco ONS 15600 Software R9.2.1.x (CD or 
soft copy)

Prerequisite Procedures None

Required

Onsite or remote

Superuser

This task verifies that all PC or UNIX workstation hardware and software 
requirements are met.

PC or UNIX workstation

Prerequisite Procedures None

Required

Onsite or remote (but in the presence of the workstation)

Superuser