Cisco Cisco Catalyst 6000 Multilayer Switch Feature Card MSFC2 Guía De Instalación

You need the following tools and equipment to remove and install Compact Flash memory cards:

ESD-preventive wrist strap

Antistatic bag or mat

Number 2 Phillips screwdriver or flat-blade screwdriver

An optional power board can be used if the Ethernet switch network module requires external -48V 
power for IP telephones. Installation and configuration of the external power suppy system is described 
in the Cisco External Power Supply for Cisco Ethernet Switch Network Modules Installation Guide. Use 
the Cisco Network Modules Hardware Installation Guide and platform hardware installation guide for 
more information.

Follow this procedure to install power boards:

Use a Philips screwdriver to remove the cover on the external power board port, as shown in 

.

Remove the thumbscrews on either side of the power board port. Put these in a safe place as they will be 
replaced once the power board is installed.

Guide the external connector through the power board port opening on the card faceplate.

Insert the connector on the power board into the connector on the network module. See 

 for 

16-port Ethernet switch network modules and 

 for 36-port Ethernet switch network modules.

Be sure to press firmly on the power board until the board seats onto the connector. 

Insert the screws from the board installation kit through the power board into the standoffs on the 
network module. 

Replace the thumbscrews on either side of the power board port. Make sure the thumbscrews are 
tightened firmly.

62426

Ext

Pwr

-48V

0x

8x

7x

15x

GE

10/100/

1000

Base-Tx

Gigabit Ethernet port cover

External power supply port cover