Cisco Cisco Unified MeetingPlace Audio Server Manual De Mantenimiento
5-11
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 5 Repairing and Maintaining the 8106 Server
Replacing the CPU
Figure 5-9
hwconfig Command
Step 5
Verify the line for the fan’s status is like line 9 in
Note
The floppy drive and CD-ROM drive do not show up in the “hwconfig” command output even
when they are installed and running.
when they are installed and running.
Replacing the CPU
The section describes how to replace the CPU card (located on the front of the server) and the CPU
transition module (located on the back of the server).
transition module (located on the back of the server).
Warning
Handling the CPU card can result in static damage. Use an anti-static wrist strap, static-dissipating
work surface, and anti-static bags when handling and storing the card.
work surface, and anti-static bags when handling and storing the card.
•
Any time the CPU card is replaced, you need new license keys for the MeetingPlace server. If you
do not have these, contact the Cisco TAC before proceeding.
do not have these, contact the Cisco TAC before proceeding.
•
The CPU card always goes into the slot labelled CPU in the front of the server. It also has a transition
module in the same slot in the back of the server. Whenever the CPU card is replaced, this transition
module must also be replaced.
module in the same slot in the back of the server. Whenever the CPU card is replaced, this transition
module must also be replaced.
meetingplace:tech$ hwconfig
Cabinet: ELMA 4U
Bus architecture: CompactPCI
Processor card: SMM5370LATUDE S/N=6055691
Processor: Pentium III, Model 8, 700 MHz
Memory: 512MB
Temperature: 22C
Voltages: 3.34V, 5.02V, 12.00V
Power Supplies: OK
Fans: OK
SCSI Adapter: NCR 810
DISK 1: 36000MB (SEAGATE ST336607LC REV=0005)
DISK 2: 36000MB (SEAGATE ST336607LC REV=0005)
Ethernet: Intel 8225x PCI 10/100 (0001af0bc2cd)
Modem: Absent or unrecognized
MultiAccess Blades:
Slot 1: AC TP1610-4 S/N=274404 REV=0 AC0
Smart Blades:
Slot 2: NMS CG6000C S/N=103237639 REV=5894-B4 MSC0 PRC0