Cisco Cisco Video Surveillance 2835 IP Camera Notas de publicación

Downgrading the firmware (from Release 1.4.1 to a previous version) resets the camera to factory reset 
mode (user and network settings are preserved) in the following cases:

The device is currently configured with the following new resolutions for either primary or 
secondary stream:

1536 x 864

1472 x 832

768 x 432

704 x 400

352 x 208

320 x 192

192 x 112

160 x 96

Primary MJPEG codec is configured on the primary stream. 

If the configured number of presets is greater than 8, all preset configurations are cleared. The camera 
does not reset.

To avoid the camera reset, change the settings before you downgrade.

 describes the caveats that are resolved in this release.

 describes the caveats that are open in this release.

You can use the Bug Toolkit to find information about caveats (bugs) for this release, including a 
description of the problems and available workarounds. The Bug Toolkit lists open and resolved caveats.

CSCuf52652

 

6930/283x: Auto Patrol does not restart after power cycle. 

CSCug60062

6930: Exposure time option may get disabled sometimes.

CSCue99434

MJPEG configuration change may take up to 5 minutes before streaming starts. 

CSCui23498 

283x/3xxx/6xxx/6930/7xxx: Camera does not send Cold Start SNMP trap.

CSCui95069 

283x/3xxx/6xxx/6930/7xxx: 802.1x does not work after certificate change.