Cisco Cisco ONS 15310-MA SONET Multiservice Platform Referencia técnica

Port number 3083 is a Telnet port that uses the Telnet protocol and associated Telnet escape 
sequences. 

Port number 2361 is supported for backward compatibility with earlier releases and has the same 
behavior as Port 3083 (Telnet port). Use the following procedure with PCs running Windows 
operating systems.

Port number 3082 is a raw TCP/IP port; it is not an interactive port and is not recommended 
for use as an alternate telnet port.

At the DOS prompt, type cmd and press Enter. (The same steps can also be done from a Unix 
prompt).

At the DOS command prompt type: 

TELNET <NODE IP ADDRESS OR NODE NAME> <PORT NUMBER> and press Enter.

The Node IP address or Node Name refers to the IP address or Node Name of the node you 
want to communicate with. Port number is the port (2361 or 3083) where TL1 commands are 
understood. If the connection is successful, a screen opens with a prompt.

You are ready to log into TL1. Follow the steps in the “4. Log Into TL1” section on page 8.

The TCC2/TCC2P card has two built-in interface ports for accessing the ONS 15454 SDH. With one 
RJ-45 LAN connection you can access the system using a standard browser interface. In the browser 
interface, you can perform local and remote Operations, Administration, Maintenance, and 
Provisioning (OAM&P) functions and open a VT100 emulation window to enter TL1 commands. If 
a browser is not available, you can access the system using a nine-pin EIA/TIA-232 port. The 
EIA/TIA-232 port supports VT100 emulation which allows TL1 commands to be entered directly 
without a browser.

Connect the serial cable to the EIA/TIA-232 port on the active TCC2/TCC2P card.

Configure the terminal emulation software (Hyperterminal):

Terminal emulation = vt100

Bits per second = 9600

Parity = None

Stop BITS = 1