Cisco Cisco ONS 15310-MA SONET Multiservice Platform Referencia técnica

Step 2

Connect a serial cable to the null modem adapter, and to the serial port on your PC or
workstation.

Step 3

Complete one of the following:

•

If you are using a PC, configure the terminal emulation software (HyperTerminal):

–

Terminal emulation = vt100

–

Bits per second = 9600

–

Parity = None

–

Stop BITS = 1

–

Flow control = None

•

If you are using a UNIX workstation, connect from X Windows or the terminal using the
tip command:

tip -9600 /dev/ttyb

Note

You might need to use ttya instead of ttyb, depending on where serial cable is
connected.

Step 4

Press Enter. A > prompt appears.

Step 5

You are ready to log into TL1. Follow the steps in the “4. Log Into TL1” section on page 8.

Use a Craft Interface to Open a TL1 Session (Cisco ONS 15310 MA-
SDH)

The CTX/CTX2500 card has two built-in interface ports for accessing the ONS 15310 MA SDH. With
one RJ-45 LAN connection you can access the system using a standard browser interface. In the
browser interface, you can perform local and remote OAM&P functions and open a VT100 emulation
window to enter TL1 commands. If a browser is not available, you can access the system using a
nine-pin EIA/TIA-232 port. The EIA/TIA-232 port supports VT100 emulation, which allows TL1
commands to be entered directly without a browser.

Step 1

Connect the serial cable to the EIA/TIA-232 port on the active CTX/CTX2500 card.

Step 2

Configure the terminal emulation software (HyperTerminal):

Terminal emulation = vt100

Bits per second = 9600

Parity = None

Stop BITS = 1