Cisco Cisco ONS 15310-MA SONET Multiservice Platform Referencia técnica

Flow control = None

Press Enter. An angle bracket prompt (>) appears.

You are ready to log into TL1. Follow the steps in the “4. Log Into TL1” section on page 8.

The TSC card has one RJ-45 port of the faceplate. The RJ-45 port allows you to access the system 
using a standard web browser. You must use the RJ-45 port on the active TSC. While using the web 
browser, you can perform local and remote OAM&P functions.

If a browser is not available, you can access the system using one of the two EIA/TIA-232 ports on the 
CAP. Each EIA/TIA-232 port supports VT100 emulation so that you can enter TL1 commands directly 
without using a web browser. Each EIA/TIA-232 port supports its own TL1 session. 

Because the CAP EIA/TIA-232 port is set up as a data terminal equipment (DTE) interface, you must 
use a 3-pair swapping null modem adapter so that the TXD/RXC, DSR/DTR, and CTS/RTS pins are 
swapped when connecting to the serial ports. The null modem adapter connects the CAP EIA/TIA-232 
port (male configuration) and the serial cable (female configuration). Table 1 lists the null modem 
adapter pin assignments.

Attach a 3-pair swapping null modem adapter to the EIA/TIA-232 port on the CAP. 

NC

1

1. NC = not connected

1

NC

RXD

2

3

TXD

3

2

DTR

4

6

GND

5

5

DSR

6

4

RTS

7

8

CTS

8

7

NC

9

NC