Cisco Cisco MGX-FRSM-HS2 B Serial Frame Service Module
3
Cisco SM-X-1T3/E3 Enhanced Service Module Configuration Guide
OL-27148-02
Cisco SM-X-1T3/E3 Enhanced Service Module Configuration Guide
Requirements for the Cisco SM-X-1T3/E3
Requirements for the Cisco SM-X-1T3/E3
Cisco IOS/IOS XE Requirements
describes Cisco IOS/IOS XE requirements for operating the Cisco SM-X-1T3/E3.
Memory Requirements
describes the minimum platform memory recommended for operating the Cisco SM-X-1T3/E3.
Configuring the SM-1T3/E3 Service Module
The SM-1T3/E3 Service Module can be configured as a T3 interface or an E3 interface. See the
following sections for configuration details:
following sections for configuration details:
•
•
•
Configuring DHCP on the Platform
The SM-1T3/E3 Service Module acquires an IP address from the platform upon boot-up. To enable this
to occur correctly, configure service dhcp in global configuration mode.
to occur correctly, configure service dhcp in global configuration mode.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ip dhcp use vrf connected
4.
service dhcp
Table 2
Cisco IOS/IOS XE Requirements
Supported Platform
IOS/IOS XE release
Cisco ISR G2 models
•
15.2(4)M4 or later
•
15.3(1)T2 or later
•
15.3(2)T1 later
Cisco ISR 4451-X routers
Cisco IOS XE release 3.9.1 or later
Table 3
Cisco SM-X-1T3/E3 Minimum Memory Requirements
Supported Platforms
Flash Memory
Cisco 2951
8 Mb
Cisco 3925/3925E
8 Mb
Cisco 3945/3945E
8 Mb
Cisco ISR 4451-X routers
8 Mb