Cisco Cisco UCS C22 M3 Rack Server Prospecto
5
Statement of Volatility for Cisco UCS Hardware
Cisco UCS 6200 Series Fabric Interconnects
Resetting the CMOS From UCS Manager
Step 1
In the UCS Manager navigation window, click the Equipment tab.
Step 2
On the Equipment tab, choose Equipment > Chassis > Chassis Number > Servers.
Step 3
Choose the server on which you want to reset the CMOS.
Step 4
In the Work pane, click the General tab.
Step 5
In the Actions area, click Recover Server.
Step 6
In the Recover Server dialog box, click Reset CMOS and then click OK.
Cisco UCS 6200 Series Fabric Interconnects
The Cisco UCS 6248 and 6296 Fabric Interconnects have multiple serial, electrically erasable, and
programmable nonvolatile memory components (EEPROM and Flash memory) that are used to store
manufacturing hardware identification and hardware configuration information. The majority of serial
EEPROMs and flash memories are not written by users and contain no customer information. The following
procedures for clearing the few flash devices that can retain customer data are included in this section:
programmable nonvolatile memory components (EEPROM and Flash memory) that are used to store
manufacturing hardware identification and hardware configuration information. The majority of serial
EEPROMs and flash memories are not written by users and contain no customer information. The following
procedures for clearing the few flash devices that can retain customer data are included in this section:
•
•
•
Restoring the eUSB Flash to factory Default Settings
This procedure restores the eUSB Flash to factory default setting.
Before you begin:
•
Physically connect the console port on the fabric interconnect to a computer terminal or console
server.
server.
•
Determine the running versions of the following firmware:
–
The firmware kernel version on the fabric interconnect
–
The firmware system version
Step 1
Connect to the console port.
Step 2
Power cycle the fabric interconnect:
a.
Turn off the power to the fabric interconnect.
b.
Turn on the power to the fabric interconnect.
Step 3
In the console, press one of the following key combinations as it boots to get the loader prompt.
Ctrl+l
Ctrl+Shift+r