Cisco Cisco Aironet 1130 AG Access Point Guía De Instalación
18
78-xxxxx-0x
Set up a terminal emulator on your PC to communicate with the access point.
Use the following settings for the terminal emulator connection: 9600 baud,
8 data bits, no parity, 1 stop bit, and no flow control.
Use the following settings for the terminal emulator connection: 9600 baud,
8 data bits, no parity, 1 stop bit, and no flow control.
When you assign an IP address to the access point using the CLI, you must
assign the address to the BVI. Beginning in a privileged EXEC mode, follow
these steps to assign an IP address to the access point’s BVI:
assign the address to the BVI. Beginning in a privileged EXEC mode, follow
these steps to assign an IP address to the access point’s BVI:
Note
When you have finished using the console port, you must remove the
serial cable from the access point.
serial cable from the access point.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
Interface bvi1
Enters interface configuration mode
for the BVI.
for the BVI.
Step 3
ip address address mask
Assigns an IP address and subnet mask
address to the BVI.
address to the BVI.