Cisco Cisco Aironet 1130 AG Access Point Guía De Instalación
19
Quick Start Guide Cisco Aironet 1130AG Access Point
Using a Telnet Session to Access the CLI
Follow these steps to browse to access the CLI using a Telnet session. These
steps are for a PC running Microsoft Windows with a Telnet terminal
application. Check your PC operating instructions for detailed instructions.
steps are for a PC running Microsoft Windows with a Telnet terminal
application. Check your PC operating instructions for detailed instructions.
1.
Select Start > Programs > Accessories > Telnet.
If Telnet is not listed in your Accessories menu, select Start > Run, type
Telnet in the entry field, and press Enter.
Telnet in the entry field, and press Enter.
2.
When the Telnet window appears, click Connect and select Remote
System.
System.
In the Host Name field, type the access point’s IP address and click Connect.
Configuring Power
After connecting the access point to a power source, its status LED might be
amber, which can indicate that the access point is unable to verify that the
PSE is supplying sufficient power. In such cases, you will need to configure
settings on the access point or the switch to identify your power source.
amber, which can indicate that the access point is unable to verify that the
PSE is supplying sufficient power. In such cases, you will need to configure
settings on the access point or the switch to identify your power source.
Identify your power source and switch condition and then make sure that your
devices are configured as indicated in the table on page 19.
devices are configured as indicated in the table on page 19.