Cisco Cisco Aironet 1310 Access Point Bridge Notas de publicación
4
Release Notes for Cisco Aironet 1300 Series Outdoor Access Point/Bridge for Cisco IOS Release 12.3(4)JA2
OL-8216-01
Installation Notes
Wireless IDS – Excess Management Frame Detection
This feature provides scanner access points the ability to detect that WLAN management and control
frames exceeded a configurable threshold.
frames exceeded a configurable threshold.
Wireless IDS – Authentication Attack Detection
This feature requires Cisco Aironet access points to detect and report on excessive attempted or failed
authentication attempts (Authentication failure detection and Excess EAPoL authentication).
authentication attempts (Authentication failure detection and Excess EAPoL authentication).
Frame Monitor Mode
This feature requires a Scan-only access point to forward all 802.11 frames seen to a protocol analysis
station for network troubleshooting from remote sites through partner applications or partner Intrusion
Detection companies or both.
station for network troubleshooting from remote sites through partner applications or partner Intrusion
Detection companies or both.
Location Based Services (LBS)
This feature allows a Cisco Aironet access point to detect frames from a LBS clients and send them to a
pre-configured IP destination, such as a third-party LBS server.
pre-configured IP destination, such as a third-party LBS server.
SNMPv3
This feature enables SNMPv3 support on Cisco Aironet access points to provide an additional level of
security.
security.
Installation Notes
This section contains important information to keep in mind when installing your access point/bridge.
Warnings
Warning
This warning means danger. You are in a situation that could cause bodily injury. Before you work on
any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents.
any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents.
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.