Cisco Cisco Aironet 350 Access Points Notas de publicación
3
Limitations and Restrictions
OL-2381-01
Limitations and Restrictions
Limitations and Restrictions
MIB File Compatible with Firmware Version 11.0x
The access point MIB file (AWCVX-MIB) is supported by access point firmware versions 11.00 and
later. Earlier versions of firmware do not support this MIB.
later. Earlier versions of firmware do not support this MIB.
EAP Authentication Requires Matching 802.1x Protocol Drafts
Note
This section applies to wireless networks set up to use LEAP. If you do not use LEAP on your
wireless network, you can skip this section.
wireless network, you can skip this section.
Wireless client devices use Extensible Authentication Protocol (EAP) to log onto a network and generate
a dynamic, client-specific WEP key for the current logon session. If your wireless network uses WEP
without EAP, client devices use the static WEP keys entered in the Aironet Client Utilities.
a dynamic, client-specific WEP key for the current logon session. If your wireless network uses WEP
without EAP, client devices use the static WEP keys entered in the Aironet Client Utilities.
If you use Network-EAP authentication on your wireless network, your client devices and access points
must use the same 802.1x protocol draft. For example, if the radio firmware on the client devices that
will associate with an access point is 4.16, then the access point should be configured to use Draft 8 of
the 802.1x protocol.
must use the same 802.1x protocol draft. For example, if the radio firmware on the client devices that
will associate with an access point is 4.16, then the access point should be configured to use Draft 8 of
the 802.1x protocol.
lists firmware versions for Cisco Aironet products and the draft with which
they comply.
Note
Draft standard 8 is the default setting in firmware version 11.05 and earlier, and it might remain in
effect when you upgrade the firmware to version 11.06 or later. Check the setting on the
Authenticator Configuration page in the management system to make sure the best draft standard for
your network is selected.
effect when you upgrade the firmware to version 11.06 or later. Check the setting on the
Authenticator Configuration page in the management system to make sure the best draft standard for
your network is selected.
Table 1
802.1x Protocol Drafts and Compliant Client Firmware
Firmware Version
Draft 7
Draft 8
Draft 10
PC/PCI cards 4.13
—
x
—
PC/PCI cards 4.16
—
x
—
PC/PCI cards 4.23
—
x
—
PC/PCI cards 4.25 and later
—
—
x
WGB34x/352 8.58
—
x
—
WGB34x/352 8.61 or later
—
—
x
AP34x/35x 11.05 and earlier
—
x
—
AP34x/35x 11.06 and later
1
1.
The default draft setting in access point and bridge firmware version 11.06
and later is Draft 10.
and later is Draft 10.
—
x
x
BR352 11.06 and later
1
—
x
x