Cisco Cisco Aironet 350 Access Points 릴리즈 노트

The access point MIB file (AWCVX-MIB) is supported by access point firmware versions 11.00 and 
later. Earlier versions of firmware do not support this MIB.

This section applies to wireless networks set up to use LEAP. If you do not use LEAP on your 
wireless network, you can skip this section.

Wireless client devices use Extensible Authentication Protocol (EAP) to log onto a network and generate 
a dynamic, client-specific WEP key for the current logon session. If your wireless network uses WEP 
without EAP, client devices use the static WEP keys entered in the Aironet Client Utilities. 

If you use Network-EAP authentication on your wireless network, your client devices and access points 
must use the same 802.1x protocol draft. For example, if the radio firmware on the client devices that 
will associate with an access point is 4.16, then the access point should be configured to use Draft 8 of 
the 802.1x protocol. 

 lists firmware versions for Cisco Aironet products and the draft with which 

they comply.

Draft standard 8 is the default setting in firmware version 11.05 and earlier, and it might remain in 
effect when you upgrade the firmware to version 11.06 or later. Check the setting on the 
Authenticator Configuration page in the management system to make sure the best draft standard for 
your network is selected.

PC/PCI cards 4.13

—

x

—

PC/PCI cards 4.16

—

x

—

PC/PCI cards 4.23

—

x

—

PC/PCI cards 4.25 and later

—

—

x

WGB34x/352 8.58

—

x

—

WGB34x/352 8.61 or later

—

—

x

AP34x/35x 11.05 and earlier

—

x

—

AP34x/35x 11.06 and later

1

1.

The default draft setting in access point and bridge firmware version 11.06 
and later is Draft 10.

—

x

x

BR352 11.06 and later

1

—

x

x