Cisco Cisco Aironet 1310 Access Point Bridge Notas de publicación

You cannot provide redundant power to 1130 series access points with both DC power to its power port 
and inline power from a patch panel or powered switch to the access point Ethernet port. If you apply 
power to the access point from both sources, the switch or power patch panel might shut down the port 
to which the access point is connected. 

 shows the power configuration that can shut down the 

port on the patch panel or powered switch.

The 1130, 1140, 1240, and 1250 series access points disable the radio interfaces when the connected 
power source does not provide enough power. Depending on your power source, you might need to enter 
the power source type in the access point configuration. Use the System Software: System Configuration 
page on the web-browser interface to select a power option. 

 shows the System Power Settings 

section of the System Configuration page.

The PoE power status can also be found in the PoE Status section on the network interfaces>network 
status page on the access point GUI. The status statements can include any of the following:

Normal (full power)

Low (radio disabled)

Lower than 15.4 W

Universal

power supply

SYST

RPS

DUPLX

MODE

SPEED

UTIL

STAT

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

23

24

10Base-T / 1

00Base-TX

100Base-FX

Catalyst 2950

 SERIES

Switch with

inline power or

power patch panel

Access point

74329