Cisco Cisco WAP150 Wireless-AC N Dual Radio Access Point with PoE Guía De Instalación

The front panel of the Cisco WAP150 consists of one system LED. For full 
descriptions of the colors of the lights and their indications, see 

.

RESET—See 

 for information on the RESET button.

LAN (PoE)—The RJ-45 Ethernet port is used to power the Cisco WAP150 
using PoE. It is an auto-sensing, Gigabit Ethernet (802.3) port used to 
connect the Cisco WAP150 to network devices, such as computers, 
routers, or switches. We strongly recommend that you use a Category 
5e or better cable for Gigabit connectivity.

POWER—The POWER button is used to turn the power on and off. It is not 
applicable when using PoE.

12V DC—The 12V DC jack is used to connect the supplied power adapter 
to the Cisco WAP150 if you are not using PoE.

Kensington Lock Slot—The Kensington lock slot is used to attach a cable 
and lock to the Cisco WAP150. 

If you are using a Cisco RV Series router, the default range for the DHCP 
assigned address is from 192.168.1.100 to 192.168.1.254. Any device 
connecting to the same LAN will be assigned an IP address in this range.

There are two ways to physically install the Cisco WAP150:

Username

Password

LAN IP Address

DHCP address assigned by server

Fallback LAN IP

Subnetwork Mask

255.255.255.0