Cisco Cisco WAP150 Wireless-AC N Dual Radio Access Point with PoE Guía De Instalación

Insecure mounting might damage the device or cause injury. 
Cisco is not responsible for damages incurred by insecure wall-
mounting.

• Ambient Temperature—To prevent the Cisco WAP150 from 

overheating, do not operate it in an area that exceeds an ambient 
temperature of 104°F (40°C).

• Air  Flow—Be sure there is adequate air flow around the device.

• Mechanical Loading—The Cisco WAP150 should be level, stable, and 

secure to prevent it from sliding or shifting out of position. 

You can perform the initial configuration using either a wired or wireless 
connection. The default configuration of the Cisco WAP150 has the Wi-Fi 
radio turned on. 

To connect the Cisco WAP150 to the wired network:

Connect the Ethernet cable to the Ethernet port of a switch, a router, 
or a PC. 

Connect the other end of the network Ethernet cable to the 
Ethernet port of the Cisco WAP150. 

If PoE is not provided, plug in the supplied power adapter to 
provide power to the Cisco WAP150. 

This wireless default configuration will not allow traffic between WiFi and 
Ethernet; users will need to go through the setup wizard to resume the 
traffic between WiFi and Ethernet.

To connect the Cisco WAP150 to the network wirelessly:

Use wireless clients to locate the WAP150’s SSID (CiscoSB-Setup). 

Use the ‘cisco123’ passkey to access the access point.

The system provides a one-time-only access to configure the 

access point using a wireless connection.