Cisco Cisco WAP150 Wireless-AC N Dual Radio Access Point with PoE Guía De Instalación

After installation, all lights should be active. Refer to 

 for details about the different lights on the Cisco 

WAP150.

To verify the hardware installation, complete the following tasks:

• Check the cable connections.

• Check the state of the indicator light.

If you need help resolving a problem, visit the Cisco Support 

Community at 

. 

To configure the Cisco WAP150, follow these steps to access the
web-based Configuration Utility and then the Setup Wizard from your 
computer:

Connect the Cisco WAP150 to the same network (IP subnet) as your 
computer. The factory default IP address configuration of the Cisco 

Off

The WAP150 is out of power.

Solid Green

The Cisco WAP150 is normal; no wireless 
client connected.

Solid Blue

The Cisco WAP150 is normal; at least one 
wireless client connected.

Solid Red

The Cisco WAP150 fails to boot with both 
firmware images.

Flashing Green

The Cisco WAP150 is booting.

Flashing Blue

Firmware upgrade is in progress.

Off

No Ethernet link.

Solid Green

Gigabit Ethernet link is active. 

Solid Amber

Fast Ethernet link is active.

Flashing

Transmitting or receiving data.