Cisco Cisco StadiumVision Mobile Reporter Manual De Mantenimiento
© 2011 Cisco Systems, Inc. All rights reserved.
Page 20 of 40
While the upgrade is in progress, the upgrade icon displays next to the selected
DMP(s) and the progress bar for the DMP(s) indicates the current progress of the
operation. The DMP will reboot after it is upgraded. The process takes about 3-4
minutes. However, the system may take longer to upgrade depending on the number
of DMPs. DMPs are upgraded in groups. A rough calculation would be the total
quantity of DMPs divided by 10 then multiplied by 2-3 minutes.
DMP(s) and the progress bar for the DMP(s) indicates the current progress of the
operation. The DMP will reboot after it is upgraded. The process takes about 3-4
minutes. However, the system may take longer to upgrade depending on the number
of DMPs. DMPs are upgraded in groups. A rough calculation would be the total
quantity of DMPs divided by 10 then multiplied by 2-3 minutes.
Any DMP 4310Gs that are selected will be ignored during the kernel upgrade. The
Skipped Devices icon
Skipped Devices icon
is displayed next to the DMP status list for skipped
DMPs.
Figure 11. Upgrading the Kernel
12. Update the MIB Variables for the kernel.
After upgrading the kernel, you may need to perform the following procedures:
Upgrading the DMP Firmware Image
Use the DMP Install > Firmware Upgrade command to upgrade the DMP firmware
image. The Firmware Upgrade command applies to both the DMP 4310G and the
image. The Firmware Upgrade command applies to both the DMP 4310G and the