Cisco Cisco 1 GHz GainMaker Amplifier Guía De Instalación
Chapter 2 Installation and Configuration
20
Installing the Power Supply
Important: The AC shunt power directors must be removed before installing the
unit. Removal of the AC shunt power directors reduces the power surge to the
components and F-connectors.
unit. Removal of the AC shunt power directors reduces the power surge to the
components and F-connectors.
CAUTION:
RF connectors and housing seizure assemblies can be damaged if AC shunt
power directors are not removed from the amplifier before installing or
removing the amplifier module from the housing.
power directors are not removed from the amplifier before installing or
removing the amplifier module from the housing.
To Install the Power Supply Module
Complete the following steps to install the power supply module.
1 Start with the housing lid open. The power supply is installed in the housing lid.
2 Install the power supply module in the power supply cavity.
1 Start with the housing lid open. The power supply is installed in the housing lid.
2 Install the power supply module in the power supply cavity.
Note:
There is only one correct way to install the power supply module. Use the
metal tabs as a guide to position the power supply module correctly inside
the power supply cavity.
metal tabs as a guide to position the power supply module correctly inside
the power supply cavity.
Be sure that the plastic retaining tabs that secure the test point plugs to the
housing lid are not pinched between the power supply and the interior of the
housing lid are not pinched between the power supply and the interior of the