Cisco Cisco 1 GHz GainMaker Amplifier Guía De Instalación
Balancing the Forward Path
47
Balancing the Forward Path
Be sure to use the correct procedure for forward path balancing. Refer to To Select
the Forward Path Balancing Procedure (on page 47) for help in identifying the
procedure that best fits your system installation and line extender type.
the Forward Path Balancing Procedure (on page 47) for help in identifying the
procedure that best fits your system installation and line extender type.
Before you begin, also make sure that the line extender module is configured
according to the specifications in the design print, and that the line extender has
warmed up for approximately one hour.
according to the specifications in the design print, and that the line extender has
warmed up for approximately one hour.
To Set the Bode Switch Mode
You can set the bode mode using the BODE Switch.
Refer to the following table to direct you to set the proper bode mode.
Bode Mode
Description
Note
Thermal / AGC mode Bode functions are enabled.
You can use all the forward path
balancing procedures except for
Forward Path Balancing for
Manual Stations (on page 73)
balancing procedures except for
Forward Path Balancing for
Manual Stations (on page 73)