Cisco Cisco Unified CallConnector for Microsoft Windows
![Cisco](https://files.manualsbrain.com/attachments/7380d0050044647c30f5c24bbbf5d0c0b6d9bb84/common/fit/150/50/faa183d287233c52228cfea3dbc2a127fe780f60564fcb0955d9c3d1cd23/brand_logo.png)
Cisco Systems, Inc.
Page 107
107
Troubleshooting
TROUBLESHOOTING
This chapter describes the common error conditions that occur with the Unified
CallConnector Mobility Service and steps to solving these problems.
CallConnector Mobility Service and steps to solving these problems.
Mobility Features Troubleshooting
Single Number Reach doesn’t work:
Description
The SNR does not launch after a personal routing policy is created.
Possible
Causes
Causes
Automation server is not running
The ephones in CME are not available
The personal routing policy is not setup correctly
The ephones in CME are not available
The personal routing policy is not setup correctly
Procedures
Step 1. Launch the CTIServer Server Manager to check the
automation server status making
sure it is ―Started‖. If not,
click Stop and wait until all servers are stopped then click
Start.
Start.
Step 1. Launch the Cisco CallConnector Server Wizard and go to the
Automation Ephone Pool setup page to verify the ephone pool
setup making sure the ephones are assigned correctly. Also, it
is required to assign SNR application to at least one ephone
pool.
setup making sure the ephones are assigned correctly. Also, it
is required to assign SNR application to at least one ephone
pool.
Step 2. Check the
personal routing policy‘s condition checks. Making
sure all the enabled conditions are matched.
The Mid-
Call Features doesn’t work:
Description
The Mid-
Call Features doesn‘t respond to the user‘s input once an SNR
session is established.
Possible
Causes
Causes
Mid-Call Features is not enabled
Hardware Conferencing is not enabled
Hardware Conferencing is not enabled
Procedures
Step 1. Launch the Cisco CallConnector Server Wizard and go to the
Automation Mobility Service setup page.
Step 2. Check the
―Allow mid-call to access features‖ option is enabled
in the Single Number Reach Options section.
Step 3. Go to the Settings to Access CME/US500 Features setup
page making sure that the option
―Use Hardware
conferencing‖ is checked.