Samsung Wireless Mono Multifunction Printer Manual De Usuario

.1   

<Getting Started>

This chapter gives you step-by-step instructions for setting up the 
machine.

This chapter includes:

This section shows the steps to set up the hardware which is explained 
in the Quick Install Guide. Make sure you read Quick Install Guide and 
complete following steps.

Select a stable location. 

Select a level, stable place with adequate space for air circulation. 
Allow extra space to open covers and trays. 

The area should be well-ventilated and away from direct sunlight or 
sources of heat, cold, and humidity. Do not set the machine close to 
the edge of your desk or table. 

Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to 
the altitude setting to optimize your printing. See page 3.9 for more 
information.

Place the machine on a flat and stable surface for not letting it lean 
more than 2 mm (0.08 inches). Otherwise, it may affect the printing 
quality.    

Unpack the machine and check all the enclosed items.

Remove the tape holding the machine tightly.

Install both the toner cartridge.

Load paper. (See "Loading paper in the tray" on page 4.5.)

Make sure that all the cables are connected to the machine. 

Turn the machine on. 

Install the software. See Software section.

This equipment will be inoperable when mains power 

fails.

When the printer driver is in installation process, the driver 
installer detects the locale information of your operating 
system, and sets the default paper size for your machine. If 
you use the different Windows locale, you must change the 
paper size of your machine for matching your commonly 
used paper size. Go to the printer properties to change the 
paper size after installation completes.

When you move the machine, do not tilt or turn it upside down. 
Otherwise, the inside of the machine may be contaminated by 
toner, which can cause damage to the machine or bad printing 
quality.