Samsung SSA-S2000 Manual De Usuario

English _ 45

TROUBLESHOOTING

troubleshooting

TROUBLESHOOTING

If the product does not function properly, please see the below for trouble shooting.

PROBLEM

ACTION

When I turn on the product, it does not 
recognize the card with just the 3 LED 
indicators blinking.

1)  Check if the product is installed properly and works normally.

       -  In the initial setup of the product or after it is initialized 

Set the operation mode and register the Master card and user cards as usual 
because the product is in the initial state.

       

c

 SSA–2000 modes available : Mode Number + ENT

        

√

 RF Only      : 01 + ENT

        

√

 RF + P/W   : 02 + ENT

        

√

 PIN Only     : 03 + ENT

        

√

 RF or PIN    : 05 + ENT

       

d

  Master Card (or (PIN): 4 ~ 6 digits (Mode 03 or 05) + ENT)

      

 

e

  Enter the user card or PIN number and provide the password according to the 

mode

       

f

  Master Card (or (PIN): 4 ~ 6 digits (Mode 03 or 05) + ENT)

        

√

  For more information about registering the Master Card and the user card, 

refer to the initial setup section in the user manual.

2)   If this happens while the product is operating normally (with the Master Card and 

user card registered)
Product malfunction

        

c

 Power: OFF 

€ ON

        

d

  If the problem persists, perform the initialization process for the next step.

        

√

  For more information about initializing the product, refer to the initialization 

section in the user manual.

3)   If the problem persists after you have followed the procedures above, contact a 

designated service center.

The product just switches to normal 
operation mode while I am registering a 
user in a set mode or confi gure the 
settings.

1)   If no key input is entered within 20 seconds in a set mode, the product will switch 

to normal operation mode automatically. (normal operation)