3com Hub 1000 SX Manual De Usuario
A
U
SING
THE
C
ONSOLE
P
ORT
The Hub 1000 SX is ready to use and requires no configuration. However,
on rare occasions you may need to confirm a POST failure, change a
port’s configuration, or update the firmware image to install a bug fix or a
standards update. The console port provides access to a simple scrolling
command line interface (CLI). By connecting the console port to a PC, you
can perform these tasks:
on rare occasions you may need to confirm a POST failure, change a
port’s configuration, or update the firmware image to install a bug fix or a
standards update. The console port provides access to a simple scrolling
command line interface (CLI). By connecting the console port to a PC, you
can perform these tasks:
■
Configure port settings
■
Display hub status
■
Update the firmware image
The console port (a DB-9 standard male connector) is located on the
Hub 1000 SX rear panel. See Figure A-1.
Hub 1000 SX rear panel. See Figure A-1.
Figure A-1 Console Port
The console port default settings are:
■
9600 baud
■
8 data bits
■
1 stop bit
■
No parity
Auto-baud and modem connections are not supported.
Console
AC
IN
RESET
CONSOLE
DC POWER
GBIC
®
3Com Corporation
Santa Clara, CA
Made in USA
!
REFER TO
INSTRUCTION MANUAL
FOR CORRECT
SELECTION OF
POWER CORD
SELECTION OF
POWER CORD
INPUT
V
A max
5
8.5
+12
2.5
-12
1.0
1.0
SUPPLY DATA
CAUTION: For continued protection
against risk of fire use only with same
type and rating of of anti-surge fuse.
against risk of fire use only with same
type and rating of of anti-surge fuse.
FUSE
2.0 A
V~
100-240
H z
50/60
A
1.0