3com Hub 1000 SX Manual De Usuario

To connect the console port when the hub is disconnected 
from power:

1 Connect a null modem cable between the PC serial port and the 

console port on the Hub 1000 SX rear panel.

2 Turn on the PC.

3 Start the terminal-emulation program.

4 Configure the program with the same settings as the Hub 1000 SX 

console interface port:

■

9600 baud

■

8 data bits 

■

1 stop bit

■

No parity

5 Reconnect the hub to the power supply.

The PC screen displays POST messages, followed by the CLI header and 
the password prompt.

When you connect the hub to power or when you press the Reset button 
on the hub’s rear panel, the PC screen displays messages while POST is 
proceeding. When POST is finished, the CLI header appears, followed by 
the password prompt. For example:

POST Level 0: PASS

Checking FDS ... valid.

Performing Level 1 Tests ...

Test: Port 0 -  Pass.

Test: Port 1 -  Pass.

Test: Port 2 -  Pass.

Test: Port 3 -  Pass.

Test: Port 4 -  Pass.

Test: Port 5 -  Pass.

Test: Port 6 -  Pass.

Test: Port 7 -  Pass.

Test: Port 8 -  Pass.

Test: Port aliasing -  Pass.

Test: MAC Address - Valid: 08004E2BA4D9

Test: Fan sense -  Pass.

POST Level 1: PASS