AMC pm-scc-80 am Manual De Usuario

 
z  This setting controls battery charging amperages and other settings. The factory 

setting for CAPACITY is 1000 amp hours for PM-SCC-50AM, 1600 amp hours 

for PM-SCC-80AM, 800 amp hours for PM-SCC-40AMW and 1600 amp hours 

for PM-SCC-80AMW. 

z  At full output capacity a PM-SCC-80AM can deliver 80 amps to a battery, this 

amount of amperage (current) is equal to the C/10 (capacity divided by ten) rate 

of a 1600 amp hour battery and, as such meets most manufacturers 

recommendations for minimum PV charging capacity. 

z  In applications with battery banks under 1600 amp hours it is recommended to 

lower the Maximum Charge Rate setting from the default 80 amps to the C10 

rate of the battery bank. 

 

 

 
z  Use Constant B-05 to allow the installer to limit the maximum charge amps 

allowed to the batteries. The factory setting is 80 amps (PM-SCC-80AM).   

 

 
z  Use Constant B-06 to adjust the Absorption voltages. The default values are 

based on the battery type and capacity selected. It is not advisable to change 

default settings unless advised by the battery manufacturer or supplier. 

 

Battery Type

Absorption Volts 

Range 

Factory 

Setting 

FLOODED 13.9V~15.2V 

14.6V 

AGM 13.7V~15.1V 14.1V 

GEL 13.6V~15.1V 14.1V 

※  The above values are based on 12V system. The values x 2 are for 24V 

system; the values x 3 are for 36V system and the values x 4 are for 48V 

system.  

 

z  Premium MPPT Series will charge at the Absorption voltage and at the length of 

time before switching to float mode. 

 

 

5-6