HP proliant dl580 Manual De Usuario

Removal and replacement procedures  48 

Removing a power supply blank 

  NOTE:  If you remove or replace the primary hot-plug power supply, use the T-15 Torx screwdriver provided 

with the server to remove the shipping screw. It is located just under the port-colored plastic handle of the 
power supply unit. 

Remove the power supply blank. 

 

To replace the component, reverse the removal procedure. 

 

Removing a redundant hot-plug power supply 

  WARNING:  To reduce the risk of electric shock, do not disassemble the power supply or 

attempt to repair it. Replace it only with the specified spare part.  

  CAUTION:  If only one power supply is installed, do not remove the power supply unless the server has 

been powered down. Removing the only operational power supply will cause an immediate power loss. 

  NOTE:  If you remove or replace the primary hot-plug power supply, use the T-15 Torx screwdriver provided 

with the server to remove the shipping screw. It is located just under the port-colored plastic handle of the 
power supply unit. 

  NOTE:  Refer to the section "Power supply LEDs (on page 

)" for information on the current status of the 

hot-plug power supply. 

Disconnect the power cord from the power supply. 

Remove the shipping screw, if applicable. 

  NOTE:  If you remove or replace the primary hot-plug power supply, use the T-15 Torx screwdriver provided 

with the server to remove the shipping screw. It is located just under the port-colored plastic handle of the 
power supply unit.