Sony har-lh500 Manual De Usuario

• Caution — The use of optical instruments with this

product will increase eye hazard.

• Should any solid object or liquid fall into the

cabinet, unplug the recorder and have it checked by
qualified personnel before operating it any further.

• Discs with non-standard shapes (e.g., heart, square,

star) cannot be played on this unit.  Attempting to
do so may damage the unit.  Do not use such discs.

• Before operating the recorder, check that the

operating voltage of the recorder is identical with
your local power supply.  The operating voltage is
indicated on the nameplate at the rear of the
recorder.

• The unit is not disconnected from the AC power

source (mains) as long as it is connected to the wall
outlet, even if the unit itself has been turned off.

• Be sure to turn off the recorder before

disconnecting the power cord.

• If you are not going to use the recorder for a long

time, be sure to disconnect the recorder from the
wall outlet.  To disconnect the AC power cord
(mains lead), grasp the plug itself; never pull the
cord.

• AC power cord must be changed only at the

qualified service shop.

• Place the recorder in a location with adequate

ventilation to prevent heat build-up in the recorder.

• Do not place the recorder on a soft surface such as a

rug that might block the ventilation holes on the
bottom.

• Do not place the recorder in a location near heat

sources, or in a place subject to direct sunlight,
excessive dust or mechanical shock.

• Do not place heavy objects such as an amplifier,

deck, etc. on top of the recorder.

If the recorder is brought directly from a cold to a
warm location, or is placed in a very damp room,
moisture may condense on the lenses inside the
recorder.  Should this occur, the recorder may not
operate properly.  In this case, remove the CD and
leave the recorder turned on for about an hour until
the moisture evaporates.

• Before playing, clean the disc with a cleaning cloth.

Wipe the disc from the center out.

• Do not use solvents such as benzene, thinner,

commercially available cleaners or anti-static spray
intended for vinyl LPs.

• Do not expose the disc to direct sunlight or heat

sources such as hot air ducts, nor leave it in a car
parked in direct sunlight.

• Do not use discs encircled with a protection ring.

This may cause a malfunction to the recorder.

• When using discs that have glue or similar tacky

substance on the label side of the disc or that used a
special ink when the label was printed, there is a
chance that the disc or label may become attached
to parts inside this unit.  When this occurs, it may
not be possible to remove the disc, and may also
cause this unit to malfunction. Be sure to check that
the label side of the disc is not sticky before using.
The following types of disc should not be used:
— Rental or used discs with attached seals where

the glue extends beyond the seal.  The perimeter
of the seal on the disc is tacky.

— Discs that have labels printed using a special ink

that feels tacky when touched.

• CDs with non-standard shapes (e.g., heart, square,

star) cannot be played on this unit.  Attempting to
do so may damage the unit.  Do not use such CDs.

Clean the cabinet, panel and controls with a soft cloth
slightly moistened with mild detergent solution.  Do
not use any type of abrasive pad, scouring powder or
solvent such as thinner, benzene or alcohol.