GE PT878GC Manual De Usuario

April 2004

Note: A complete installation involves the clamping fixture, 

transducers and dampening material. If you are using 
dampening material, refer to Installing Dampening 
Material on page 3-21.

To install the V Series clamping fixture and transducers, 
complete the following steps:

Installing the Fixture

1. Position the half of the clamping fixture with the threaded 

rods around the pipe, as shown in Figure 3-7 below. Orient the 
fixture in the 3 o’clock position on a horizontal pipe. 

2. Position the mating half of the fixture over the threaded rods 

in the 9 o’clock position. Figure 3-7 below shows the two 
mounted halves. 

Note: If you are using a V4 fixture with a 1.5 to 2-in. pipe, GE