U-Line CLRCO2075 Manual De Usuario

www.U-LineService.com

02/2005

™

4. Remove the two door closer inserts from the existing 

bottom hinge and install as shown on the new bottom 
hinge (see Figure 8).

5. Remove existing bottom hinge (3 screws) and remount 

on opposite side TOP. Remove hinge screw pin.

6. Remove the plastic hole plug from the top of the door 

to allow the pivot pin to be inserted in the new 
location. Install the plug into the vacated hole on the 
opposite side.

7. With bottom of door facing up, remove pivot plate 

(2 screws), flip over, and remount on opposite side of 
door (see Figure 9). Be sure notch in plate faces center.

8. Holding door upright with top of door tilted forward, 

place hole of door pivot plate on bottom hinge screw 
pin (see Figure 10).

9. Tilt top of door into 

position in top hinge and 
install top hinge screw pin.

10. Install plastic screw plugs 

removed in Step 2 in old 
hinge holes (3 each, top 
and bottom).

The unit requires a grounded and polarized 115 VAC, 
60 Hz, 15A circuit (normal household current). See 
Electrical Specifications on Page 16.

The unit requires a 1/4-inch OD water supply line and a 
shut-off valve. For more information see Page 15.

The unit’s generous 7-inch drain connection height 
extends the distance the unit can be located from a 
gravity drain. For more information see Page 13.

Drain can NOT be located directly below unit. Unit has a 
solid base that will not allow unit to drain below itself.

The surrounding air temperature must be at least 50°F 
(10°C) but must not exceed 110°F (40°C). High ambient 
temperature ranges and warmer water supply will cause 
reduced ice production. All units may be installed 
outdoors in a covered area. The unit must not be located 
near heat-generating equipment or in direct sunlight.

Hinge

Screw

Pin

Door

Closer

Inserts