bobcat t190 Manual De Usuario
T190 Compact Track Loader
41
Operation & Maintenance Manual
Removing
Enter the loader.
Perform the PRE-STARTING PROCEDURE. (See PRE-
STARTING PROCEDURE on Page 27.)
STARTING PROCEDURE on Page 27.)
Start the engine.
Release the parking brake.
Be sure the lift arms are all the way down. Tilt the
Bob-Tach forward.
Bob-Tach forward.
Lower or close the hydraulic equipment (If Equipped).
•
If the attachment is hydraulically controlled
(combination bucket, backhoe, etc.), stop the engine
and relieve hydraulic pressure at the quick couplers.
(See Relieve Hydraulic Pressure (Loader And
Attachment) on Page 23.)
(combination bucket, backhoe, etc.), stop the engine
and relieve hydraulic pressure at the quick couplers.
(See Relieve Hydraulic Pressure (Loader And
Attachment) on Page 23.)
Exit the loader and disconnect the hydraulic hoses
from the attachment.
from the attachment.
Enter the loader.
Perform the PRE-STARTING PROCEDURE. (See
PRE-STARTING PROCEDURE on Page 27.)
PRE-STARTING PROCEDURE on Page 27.)
Start the engine.
Release the parking brake.
Figure 83
Pull the Bob-Tach levers [Figure 83] all the way up.
WARNING
Bob-Tach levers have spring tension. Hold lever
tightly and release slowly. Failure to obey warning
can cause injury.
tightly and release slowly. Failure to obey warning
can cause injury.
W-2054-1285
Figure 84
Move the loader backward, away from the bucket or
attachment [Figure 84].
attachment [Figure 84].
WARNING
Before you leave the operator’s seat:
•
•
Lower the lift arms, put the attachment flat on the
ground.
ground.
•
Stop the engine.
•
Engage the parking brake.
•
Raise seat bar.
•
(Foot Pedal Controls) Move pedals until both
lock.
lock.
•
(Advanced Control system - ACS) Move the
hydraulic controls to the NEUTRAL POSITION to
make sure that both lift and tilt functions are
deactivated.
The seat bar system must deactivate the lift and
tilt control functions when the seat bar is up.
Service the system if hand controls do not
deactivate.
hydraulic controls to the NEUTRAL POSITION to
make sure that both lift and tilt functions are
deactivated.
The seat bar system must deactivate the lift and
tilt control functions when the seat bar is up.
Service the system if hand controls do not
deactivate.
•
(Selectable Joystick Controls - SJC) Move the
joysticks to the NEUTRAL POSITION to make
sure that travel and hydraulic functions are
deactivated.
The seat bar system must deactivate these
functions when the seat bar is up. Service the
system if controls do not deactivate.
joysticks to the NEUTRAL POSITION to make
sure that travel and hydraulic functions are
deactivated.
The seat bar system must deactivate these
functions when the seat bar is up. Service the
system if controls do not deactivate.
W-2463-0603
P-31693A
P-24490A