U-Line CLR2060 Manual De Usuario

02/2005

www.U-LineService.com

™

2. If the ice maker is not level, adjust the feet on the 

corners of the unit as necessary (see Figure 44).

3. Check the levelness after each adjustment and repeat 

the previous steps until the unit is level. Go on to 
9 Install the Unit.

If the room floor is higher than the floor in the cut-out 
opening, adjust the rear feet to achieve a total unit rear 
height of 1/8" less than the opening’s rear height. Shorten 
the unit height in the front by adjusting the front feet. 
This allows the unit to be gently tipped into the opening. 
Readjust the front feet to level the unit after it is correctly 
positioned in the opening.

1. Open the water supply valve in the main water source.

2. Plug in the power cord.

3. Gently push the unit into position. Be careful not to 

kink the drain or water supply line or entangle the 
electrical cord. 

4. Re-check the leveling, from front to back and side to 

side. Make any necessary adjustments. The unit’s top 
surface should be approximately 1/8" below the 
countertop.

5. Test the drain system by pouring one gallon of water 

into the ice bin. The water should drain freely and there 
should be no leakage.

Turn Foot to Adjust