BMI Technologies Inc. RFVI Manual De Usuario
G FORCE PLUS RF Instruction Manual
Apr/08
50
Doc #RF1 Rev.9
“LOGIN DECLINED CARD EXPIRED”
Expired Operator or Lockout Card, or Operator Card
with an expired Recertification Date
with an expired Recertification Date
“LOGIN DELINED NOT AUTHORIZED” Operator Card with wrong Authorization Group or
Single Vehicle assignments, or unassigned Operator
Card
Card
VEHICLE INSPECTION
1. Press {Yes} on the Vehicle Interface when it displays “VEH INSPECTION YES TO START” The
Vehicle Interface will display the first item on the list as defined in the Authorization Group for the
Vehicle. The Vehicle Interface will revert to “OPERATOR LOGIN PRESENT CARD” if {No} or
{Cancel} is pressed.
Vehicle. The Vehicle Interface will revert to “OPERATOR LOGIN PRESENT CARD” if {No} or
{Cancel} is pressed.
2. Conduct the necessary test (i.e. visual inspection or operation of controls) to determine if the item should
pass or fail.
3. Press {Pass} on the Vehicle Interface to indicate the item has passed. The Vehicle Interface will display
the next item on the list as defined in the Authorization Group for the Vehicle. Repeat steps 2 and 3 until
the Vehicle Interface displays “VEH INSPECTION COMPLETE, PASSED”, OR
the Vehicle Interface displays “VEH INSPECTION COMPLETE, PASSED”, OR
4. Press {Fail} on the Vehicle Interface to indicate the item has failed. The Vehicle Interface will display
“VEH INSPECTION FAILURE? YES/NO”
5. Press {Yes} to confirm the failure of the Vehicle Inspection. The Vehicle Interface will display “MAINT
LOCK OUT YYYY/MM/DD HH:MM” to indicate it is in Maintenance Lockout, OR
6. Press {No} to cancel the failure of the Vehicle Inspection. The Vehicle Interface will display the item in
question again and wait for a {Pass} or {Fail} key press.
7. The Vehicle Interface will revert to “OPERATOR LOGIN PRESENT CARD” if {Cancel} is pressed
in response to any Vehicle Inspection item.
8. The Vehicle Interface will revert to “OPERATOR LOGIN PRESENT CARD” if there is no keypad
response from the Operator within the period of time determined by the Vehicle Inspection Inactivity
Timer under the System Settings.
Timer under the System Settings.
OPERATING
1. A Vehicle enters Operating state after a Passed Vehicle Inspection, or after a successful Operator Login if
no Vehicle Inspection was required. The Vehicle Interface will display “OPERATING MODE”. This
message will alternate with “BATTERY (STATE OF CHARGE)” if the Authorization Group of the
Vehicle requires Battery Monitoring.
message will alternate with “BATTERY (STATE OF CHARGE)” if the Authorization Group of the
Vehicle requires Battery Monitoring.
2. Key-off the Vehicle to end the Login session for the current Operator.