BMI Technologies Inc. VUI00 Manual De Usuario
DRAFT G FORCE PLUS & G FORCE PLUS RF Instruction Manual
Doc #RF1 Rev.2
11
Nov 2005
Use the metal bracket provided to mount the Remote Sensor as parallel to the floor as possible,
and so that the labelled arrows match the direction of the vehicle’s travel (the cable should exit
from the top or bottom of the Remote Sensor).
from the top or bottom of the Remote Sensor).
Or if preferred, clean the mounting surface thoroughly with degreaser and then mount the Remote
Sensor using the 3M™ Dual Lock™ provided.
Feed the Remote Sensor cable to the Vehicle Monitor and plug the cable end’s 6-pin male
connector into the 6-pin female receptacle on the Vehicle Monitor. Secure the connector.
Secure the cable to the vehicle within 3 inches of the Remote Sensor.
6. Mount the Auxiliary Horn.
The optimal location for the Auxiliary Horn is where it will be audible and safe from electrical
controls, engine heat and vandalism.
Clean the mounting surface thoroughly with degreaser and then mount the Horn using the 3M™
Dual Lock™ provided.
7. Mount and connect the antenna (G FORCE PLUS RF only).
Note: This device exceeds the FCC/IC requirements for RF exposure when the antenna used for
this transmitter has a separation distance of at least 20 cm from all persons and must not be co-
located or operating in conjunction with any other antenna or transmitter which is closer than 20
cm. The installer of this radio equipment must ensure that the antenna is located or pointed such
that it does not emit RF field in excess of Health Canada limits for the general population as
indicated by Safety Code 6.
located or operating in conjunction with any other antenna or transmitter which is closer than 20
cm. The installer of this radio equipment must ensure that the antenna is located or pointed such
that it does not emit RF field in excess of Health Canada limits for the general population as
indicated by Safety Code 6.
Note: The provided antenna, which operates in the 902 to 928 MHz frequency band, and antenna
extension cable, must be used with the G FORCE PLUS RF Vehicle Monitor. No substitutions
are allowed.
are allowed.
Note: The G FORCE PLUS RF Vehicle Monitor antenna and the G FORCE PLUS Vehicle
Interface may not be located closer than 20cm to each other.
The optimal location for the antenna is:
On a rigid part of the vehicle, safe from electrical controls, engine heat, moving parts and
vandalism,
As high as possible from the floor,
At least two feet away from any large metal mass for best communications results.
At least two feet away from any large metal mass for best communications results.
Attach the metal bracket provided to the selected location so the antenna will be vertical.
Insert the antenna into the bracket slot and secure the antenna by tightening the nut.
Prevent movement/vibration of the metal connector located between the short black and long
Insert the antenna into the bracket slot and secure the antenna by tightening the nut.
Prevent movement/vibration of the metal connector located between the short black and long
copper-colored cables by securing the cables and protecting the connector if necessary.
Wire the Vehicle Monitor.
Remove the Installation Bypass Plug from the end of the Wiring Harness and connect the Wiring
Harness to the Vehicle Monitor.
Connect the wires to the vehicle as follows:
DO WE NEED TO REINFORCE MAXIMUM CURRENT FOR WIRES?
Orange wire – battery positive: Connect this wire to unswitched battery positive on a 12-
volt battery. Tie this wire back if it is not used.
NOTE!
Keep the Installation Bypass Plug in a safe place.
You will need it again for step 9.