BMI Technologies Inc. VUI00 Manual De Usuario
DRAFT G FORCE PLUS & G FORCE PLUS RF Instruction Manual
Nov 2005
12
Doc #RF1 Rev.2
Red wire – battery positive: Connect this wire to unswitched battery positive on a 24- or
36-volt battery. Tie this wire back if it is not used, or if this is an internal-combustion vehicle
installation.
installation.
White/Red wire – battery positive: Connect this wire to unswitched battery positive on a
48-, 60-, 72- or 80-volt battery. Tie this wire back if it is not used, or if this is an internal-
combustion vehicle installation.
combustion vehicle installation.
Black wire – battery negative: For battery-powered vehicles, connect this wire directly to
battery negative as close to the battery terminal as possible. For internal-combustion
vehicles, connect this wire to the frame or any vehicle ground.
vehicles, connect this wire to the frame or any vehicle ground.
Green wires – key on detect: Connect one green wire to switched battery plus. Connect the
second green wire directly to battery minus as close to the battery terminal as possible. For
internal-combustion vehicles, connect the second green wire to the frame or any vehicle
ground.
internal-combustion vehicles, connect the second green wire to the frame or any vehicle
ground.
Yellow wires – Auxiliary Horn: Connect one yellow wire to one of the two Auxiliary Horn
terminals labelled “SW”. Connect the second yellow wire to the second Auxiliary Horn
“SW” terminal. Use a suitable length of red wire to make a connection between the positive
terminal on the Auxiliary Horn (labelled “+”) and battery positive. An unused portion of red
battery positive wire from the Wiring Harness may be used. Similarly, use a suitable length
of black wire to make a connection between the negative terminal on the Auxiliary Horn
(labelled “–”) and battery negative. An unused portion of black battery negative wire from
the Wiring Harness may be used.
“SW” terminal. Use a suitable length of red wire to make a connection between the positive
terminal on the Auxiliary Horn (labelled “+”) and battery positive. An unused portion of red
battery positive wire from the Wiring Harness may be used. Similarly, use a suitable length
of black wire to make a connection between the negative terminal on the Auxiliary Horn
(labelled “–”) and battery negative. An unused portion of black battery negative wire from
the Wiring Harness may be used.
White wires – digital sense input: These wires are used to detect vehicle motion or lift
operation. Contact BMI Technologies Inc. at 1-800-563-8867 for technical assistance for
your particular installation.
your particular installation.