Arescom Inc. AG2000S Manual De Usuario
Setup Instructions
8
June, 2002
AG2000Series Software User’s Guide
2.3 Setup Instructions
Before you start the setup process, make sure you follow the instructions below:
Step 1. Disconnect the broadband service. Make sure your Cable or DSL broadband connection is shut down
properly.
Step 2. Turn off the power. Make sure the Cable/ DSL modem and AG2000 equipment are all turned off.
Complete the steps below to connect the cables to the AG2000:
Step 3. Connecting the external antenna.
Tightly attach the external antenna (included) to the antenna connector on the
back panel (For maximum range, make sure the antennas are perpendicular to the
ground).
back panel (For maximum range, make sure the antennas are perpendicular to the
ground).
Step 4. Connecting to the LAN port.
Connect the RJ-45 Ethernet cable (included) from the wired Ethernet LAN
(such as a PC, hub or switch) to the LAN port of the AG2000.
(such as a PC, hub or switch) to the LAN port of the AG2000.
Step 5. Connecting to the WAN port.
Connect the RJ-45 Ethernet cable to the AG2000’s WAN port and the other end of the
same Ethernet cable to the Ethernet port of your existing DSL or Cable modem.
same Ethernet cable to the Ethernet port of your existing DSL or Cable modem.
Step 6. Connecting the power.
Connect the AC power adapter to the POWER port of the AG2000. Connect
the AC plug from the power adapter into a wall outlet or power strip.
the AC plug from the power adapter into a wall outlet or power strip.
Step 7. Turning on the power
Power on your DSL/Cable modem first, then power on your AG2000.